Re: procom aal0 mode
Thomas Gellekum <[email protected]> 27 Jun 2003 09:46:02 +0200
| Newsgroups | gmane.os.freebsd.devel.atm |
|---|---|
| Message-ID | <[email protected]> |
Harti Brandt <[email protected]> writes: > On Thu, 26 Jun 2003, Anil Madhavapeddy wrote: > > AM>> NB: the hatm driver I just commited supports AAL0. On a 1GHz machine I can > AM>> route up to 150000cells/sec through the kernel. > AM> > AM>Good speeds - this is for the devices that use the utopia phy only? > AM>I'm starting to hate my IDT77252 :-) > > All the cards I have use utopia. The 77252 is a pin-compatible replacement for the 77211, so it also uses a utopia interface. The driver needs some changes, though. Harti, didn't you mention you were adapting the driver for the Prosum cards? Apart from a PCI vendor ID, that one should work for any 77252 based card out there. tg _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-atm To unsubscribe, send any mail to "[email protected]"