svn commit: r52744 - in head: en_US.ISO8859-1/books/handbook/advanced-networking en_US.ISO8859-1/books/handbook/multimedia share/xml
Benedict Reuschling <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.cvs.doc |
|---|---|
| Message-ID | <[email protected]> |
Author: bcr Date: Wed Jan 2 18:01:55 2019 New Revision: 52744 URL: https://svnweb.freebsd.org/changeset/doc/52744 Log: Add more information about Bluetooth usage. The patch shows how to create a remote device connection and how to manage devices in /etc/bluetooth/hosts. The multimedia chapter was extended with a description on how to set up and connect a Bluetooth audio device as a sound sink. It also adds man page references to man-refs.ent for hcsecd(8) and virtual_oss(8), respectively. I cleaned up the patch a bit for consistency and proper markup. PR: 228879 Submitted by: [email protected] Take a look at this PR by: lme Modified: head/en_US.ISO8859-1/books/handbook/advanced-networking/chapter.xml head/en_US.ISO8859-1/books/handbook/multimedia/chapter.xml head/share/xml/man-refs.ent Modified: head/en_US.ISO8859-1/books/handbook/advanced-networking/chapter.xml ============================================================================== --- head/en_US.ISO8859-1/books/handbook/advanced-networking/chapter.xml Mon Dec 31 15:53:36 2018 (r52743) +++ head/en_US.ISO8859-1/books/handbook/advanced-networking/chapter.xml Wed Jan 2 18:01:55 2019 (r52744) @@ -55,6 +55,10 @@ <para>How to configure multiple <acronym>VLANs</acronym> on &os;.</para> </listitem> + + <listitem> + <para>Configure bluetooth headset.</para> + </listitem> </itemizedlist> <para>Before reading this chapter, you should:</para> @@ -2365,8 +2369,9 @@ ubt0: Interface 1 (alt.config 5) endpoints: isoc-in=0x <para>To start and stop the Bluetooth stack, use its startup script. It is a good idea to stop the stack before unplugging - the device. When starting the stack, the output should be - similar to the following:</para> + the device. Starting the bluetooth stack might require + &man.hcsecd.8; to be started. When starting the stack, the + output should be similar to the following:</para> <screen>&prompt.root; <userinput>service bluetooth start ubt0</userinput> BD_ADDR: 00:02:72:00:d4:1a @@ -2420,9 +2425,9 @@ Inquiry complete. Status: No error [00]</screen> Bluetooth device, similar to the <acronym>MAC</acronym> address of a network card. This address is needed for further communication with a device and it is possible to assign a - human readable name to a BD_ADDR. Information regarding the - known Bluetooth hosts is contained in - <filename>/etc/bluetooth/hosts</filename>. The following + human readable name to a <literal>BD_ADDR</literal>. + Information regarding the known Bluetooth hosts is contained + in <filename>/etc/bluetooth/hosts</filename>. The following example shows how to obtain the human readable name that was assigned to the remote device:</para> @@ -2435,11 +2440,25 @@ Name: Pav's T39</screen> <quote>your.host.name (ubt0)</quote>. The name assigned to the local device can be changed at any time.</para> + <para>Remote devices can be assigned aliases in + <filename>/etc/bluetooth/hosts</filename>. More information + about <filename>/etc/bluetooth/hosts</filename> file might be + found in &man.bluetooth.hosts.5;.</para> + <para>The Bluetooth system provides a point-to-point connection between two Bluetooth units, or a point-to-multipoint connection which is shared among several Bluetooth devices. - The following example shows how to obtain the list of active - baseband connections for the local device:</para> + The following example shows how to create a connection to a + remote device:</para> + + <screen>&prompt.user; <userinput>hccontrol -n ubt0hci create_connection <replaceable>BT_ADDR</replaceable></userinput></screen> + + <para><literal>create_connection</literal> accepts + <literal>BT_ADDR</literal> as well as host aliases in + <filename>/etc/bluetooth/hosts</filename>.</para> + + <para>The following example shows how to obtain the list of + active baseband connections for the local device:</para> <screen>&prompt.user; <userinput>hccontrol -n ubt0hci read_connection_list</userinput> Remote BD_ADDR Handle Type Mode Role Encrypt Pending Queue State Modified: head/en_US.ISO8859-1/books/handbook/multimedia/chapter.xml ============================================================================== --- head/en_US.ISO8859-1/books/handbook/multimedia/chapter.xml Mon Dec 31 15:53:36 2018 (r52743) +++ head/en_US.ISO8859-1/books/handbook/multimedia/chapter.xml Wed Jan 2 18:01:55 2019 (r52744) @@ -84,6 +84,10 @@ <listitem> <para>Configure an image scanner.</para> </listitem> + + <listitem> + <para>Configure a Bluetooth headset.</para> + </listitem> </itemizedlist> <para>Before reading this chapter, you should:</para> @@ -284,6 +288,49 @@ pcm2: <Conexant CX20590 (Analog 2.0+HP/2.0)> (pl do not exist and will not appear in the output of &man.ls.1;.</para> </note> + </sect2> + + <sect2 xml:id="bluetooth-headset"> + <title>Setting up Bluetooth Sound Devices</title> + + <indexterm> + <primary>Bluetooth audio</primary> + </indexterm> + + <para>Connecting to a Bluetooth device is out of scope for this + chapter. Refer to <xref + linkend="network-bluetooth"/> for more information.</para> + + <para>To get Bluetooth sound sink working with FreeBSD's sound + system, users have to install + <package>audio/virtual_oss</package> first:</para> + + <screen>&prompt.root; <userinput>pkg install virtual_oss</userinput></screen> + + <para><package>audio/virtual_oss</package> requires + <literal>cuse</literal> to be loaded into the kernel:</para> + + <screen>&prompt.root; <userinput>kldload cuse</userinput></screen> + + <para>To load <literal>cuse</literal> during system startup, run + this command:</para> + + <screen>&prompt.root; <userinput>sysrc -f /boot/loader.conf cuse_load=yes</userinput></screen> + + <para>To use headphones as a sound sink with + <package>audio/virtual_oss</package>, users need to create a + virtual device after connecting to a Bluetooth audio + device:</para> + + <screen>&prompt.root; <userinput>virtual_oss -C 2 -c 2 -r 48000 -b 16 -s 768 -R /dev/null -P /dev/bluetooth/<replaceable>headphones</replaceable> -d dsp</userinput></screen> + + <note> + <para><replaceable>headphones</replaceable> in this example is + a hostname from <filename>/etc/bluetooth/hosts</filename>. + <literal>BT_ADDR</literal> could be used instead.</para> + </note> + + <para>Refer to &man.virtual_oss.8; for more information.</para> </sect2> <sect2 xml:id="troubleshooting"> Modified: head/share/xml/man-refs.ent ============================================================================== --- head/share/xml/man-refs.ent Mon Dec 31 15:53:36 2018 (r52743) +++ head/share/xml/man-refs.ent Wed Jan 2 18:01:55 2019 (r52744) @@ -303,6 +303,7 @@ <!ENTITY man.h2xs.1 "<citerefentry xmlns='http://docbook.org/ns/docbook'><refentrytitle>h2xs</refentrytitle><manvolnum>1</manvolnum></citerefentry>"> <!ENTITY man.hash.1 "<citerefentry xmlns='http://docbook.org/ns/docbook'><refentrytitle>hash</refentrytitle><manvolnum>1</manvolnum></citerefentry>"> <!ENTITY man.hashstat.1 "<citerefentry xmlns='http://docbook.org/ns/docbook'><refentrytitle>hashstat</refentrytitle><manvolnum>1</manvolnum></citerefentry>"> +<!ENTITY man.hcsecd.8 "<citerefentry xmlns='http://docbook.org/ns/docbook'><refentrytitle>hcsecd</refentrytitle><manvolnum>8</manvolnum></citerefentry>"> <!ENTITY man.hd.1 "<citerefentry xmlns='http://docbook.org/ns/docbook'><refentrytitle>hd</refentrytitle><manvolnum>1</manvolnum></citerefentry>"> <!ENTITY man.head.1 "<citerefentry xmlns='http://docbook.org/ns/docbook'><refentrytitle>head</refentrytitle><manvolnum>1</manvolnum></citerefentry>"> <!ENTITY man.hesinfo.1 "<citerefentry xmlns='http://docbook.org/ns/docbook'><refentrytitle>hesinfo</refentrytitle><manvolnum>1</manvolnum></citerefentry>"> @@ -812,6 +813,7 @@ <!ENTITY man.vidfont.1 "<citerefentry xmlns='http://docbook.org/ns/docbook'><refentrytitle>vidfont</refentrytitle><manvolnum>1</manvolnum></citerefentry>"> <!ENTITY man.view.1 "<citerefentry xmlns='http://docbook.org/ns/docbook'><refentrytitle>view</refentrytitle><manvolnum>1</manvolnum></citerefentry>"> <!ENTITY man.vim.1 "<citerefentry xmlns='http://docbook.org/ns/docbook' vendor='ports'><refentrytitle>vim</refentrytitle><manvolnum>1</manvolnum></citerefentry>"> +<!ENTITY man.virtual_oss.8 "<citerefentry xmlns='http://docbook.org/ns/docbook' vendor='ports'><refentrytitle>virtual_oss</refentrytitle><manvolnum>8</manvolnum></citerefentry>"> <!ENTITY man.vis.1 "<citerefentry xmlns='http://docbook.org/ns/docbook'><refentrytitle>vis</refentrytitle><manvolnum>1</manvolnum></citerefentry>"> <!ENTITY man.vt220keys.1 "<citerefentry xmlns='http://docbook.org/ns/docbook'><refentrytitle>vt220keys</refentrytitle><manvolnum>1</manvolnum></citerefentry>"> <!ENTITY man.vttest.1 "<citerefentry xmlns='http://docbook.org/ns/docbook'><refentrytitle>vttest</refentrytitle><manvolnum>1</manvolnum></citerefentry>"> _______________________________________________ [email protected] mailing list https://lists.freebsd.org/mailman/listinfo/svn-doc-all To unsubscribe, send any mail to "[email protected]"