git: 3c990d4144 - main - handbook/advanced-networking: update lagg protocols
Ceri Davies <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.cvs.doc |
|---|---|
| Message-ID | <[email protected]> |
The branch main has been updated by ceri: URL: https://cgit.FreeBSD.org/doc/commit/?id=3c990d4144947009c62338a1f2236f1ae02d7f0c commit 3c990d4144947009c62338a1f2236f1ae02d7f0c Author: Ceri Davies <[email protected]> AuthorDate: 2021-07-26 20:09:13 +0000 Commit: Ceri Davies <[email protected]> CommitDate: 2021-07-26 20:20:28 +0000 handbook/advanced-networking: update lagg protocols "fec" isn't a valid laggproto since 2015, so remove it along with an explanation of what it stands for. "broadcast" was missing. --- .../content/en/books/handbook/advanced-networking/_index.adoc | 8 +++++--- 1 file changed, 5 insertions(+), 3 deletions(-) diff --git a/documentation/content/en/books/handbook/advanced-networking/_index.adoc b/documentation/content/en/books/handbook/advanced-networking/_index.adoc index b8ea334437..9b02c75cfc 100644 --- a/documentation/content/en/books/handbook/advanced-networking/_index.adoc +++ b/documentation/content/en/books/handbook/advanced-networking/_index.adoc @@ -2257,9 +2257,8 @@ If the master port becomes unavailable, the next active port is used. The first interface added to the virtual interface is the master port and all subsequently added interfaces are used as failover devices. If failover to a non-master port occurs, the original port becomes master once it becomes available again. -fec / loadbalance:: -Cisco(R) Fast EtherChannel(R) (FEC) is found on older Cisco(R) switches. -It provides a static setup and does not negotiate aggregation with the peer or exchange frames to monitor the link. +loadbalance:: +This provides a static setup and does not negotiate aggregation with the peer or exchange frames to monitor the link. If the switch supports LACP, that should be used instead. lacp:: @@ -2275,6 +2274,9 @@ roundrobin:: This mode distributes outgoing traffic using a round-robin scheduler through all active ports and accepts incoming traffic from any active port. Since this mode violates Ethernet frame ordering, it should be used with caution. +broadcast:: +This mode sends outgoing traffic to all ports configured on the lagg interface, and receives frames on any port. + === Configuration Examples This section demonstrates how to configure a Cisco(R) switch and a FreeBSD system for LACP load balancing. _______________________________________________ [email protected] mailing list https://lists.freebsd.org/mailman/listinfo/dev-commits-doc-all To unsubscribe, send any mail to "[email protected]"