git: 67232f1a2d - main - FAQ - fix single-user mode boot instructions

The branch main has been updated by carlavilla:

URL: https://cgit.FreeBSD.org/doc/commit/?id=67232f1a2d5e0254a807bebb5fb90d47ff3545b7

commit 67232f1a2d5e0254a807bebb5fb90d47ff3545b7
Author:     Big Sneaky <[email protected]>
AuthorDate: 2026-04-26 06:57:06 +0000
Commit:     Sergio Carlavilla Delgado <[email protected]>
CommitDate: 2026-04-26 06:57:06 +0000

    FAQ - fix single-user mode boot instructions
    
    PR:             291048
    Pull Request:   https://github.com/freebsd/freebsd-doc/pull/635
---
 documentation/content/en/books/faq/_index.adoc | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/documentation/content/en/books/faq/_index.adoc b/documentation/content/en/books/faq/_index.adoc
index e421019dcb..ae1b596337 100644
--- a/documentation/content/en/books/faq/_index.adoc
+++ b/documentation/content/en/books/faq/_index.adoc
@@ -436,10 +436,10 @@ bindkey ^[[3~ delete-char # for xterm
 === I have forgotten the root password! What do I do?
 
 Do not panic!
-Restart the system, type `boot -s` at the `Boot:` prompt to enter single-user mode.
+Restart the system and select `Boot Single User` from the boot loader menu, or press `Escape` at the menu and type `boot -s` at the loader prompt, to enter single-user mode.
 At the question about the shell to use, hit kbd:[Enter] which will display a # prompt.
 Enter `mount -urw /` to remount the root file system read/write, then run `mount -a` to remount all the file systems.
-Run `passwd root` to change the `root` password then run man:exit[1] to continue booting.
+Run `passwd root` to change the `root` password then run `exit` to continue booting.
 
 [TIP]
 ====
@@ -458,7 +458,7 @@ For more information see the section about encrypted disks in the FreeBSD extref
 [[rcconf-readonly]]
 === I made a mistake in rc.conf, or another startup file, and now I cannot edit it because the file system is read-only. What should I do?
 
-Restart the system using `boot -s` at the loader prompt to enter single-user mode.
+Restart the system and select `Boot Single User` from the boot loader menu, or press `Escape` at the menu and type `boot -s` at the loader prompt, to enter single-user mode.
 When prompted for a shell pathname, press kbd:[Enter] and run `mount -urw /` to re-mount the root file system in read/write mode.
 You may also need to run `mount -a -t ufs` to mount the file system where your favorite editor is defined.
 If that editor is on a network file system, either configure the network manually before mounting the network file systems, or use an editor which resides on a local file system, such as man:ed[1].