firewire disk disconnected but da* remains?
Andriy Gapon <[email protected]>
| Newsgroups | gmane.os.freebsd.stable,gmane.os.freebsd.devel.firewire |
|---|---|
| Message-ID | <[email protected]> |
I am a firewire newbie, so forgive me the following question. I disconnect external firewire HDD, firewire subsystem notices this but da0 device entry persists. Is this correct/expected behavior? on connect: kernel: fwohci0: BUS reset kernel: fwohci0: node_id=0xc800ffc1, gen=2, CYCLEMASTER mode kernel: firewire0: 2 nodes, maxhop <= 1, cable IRM = 1 (me) kernel: firewire0: bus manager 1 (me) kernel: fwohci0: txd err=14 ack busy_X last message repeated 2 times kernel: fwohci0: BUS reset kernel: fwohci0: node_id=0xc800ffc1, gen=3, CYCLEMASTER mode kernel: firewire0: 2 nodes, maxhop <= 1, cable IRM = 1 (me) kernel: firewire0: bus manager 1 (me) kernel: firewire0: New S400 device ID:0050770e00071002 kernel: da0 at sbp0 bus 0 target 0 lun 0 kernel: da0: <Prolific (1394-ATAPI rev1 2804> Fixed Simplified Direct Access SCSI-4 device kernel: da0: 50.000MB/s transfers kernel: da0: 381554MB (781422768 512 byte sectors: 255H 63S/T 48641C) kernel: GEOM_LABEL: Label for provider da0s1 is ufs/extbackup. on disconnect: kernel: fwohci0: BUS reset kernel: fwohci0: node_id=0xc800ffc0, gen=4, CYCLEMASTER mode kernel: firewire0: 1 nodes, maxhop <= 0, cable IRM = 0 (me) kernel: firewire0: bus manager 0 (me) camcontrol rescan all done some time later stuck in cbwait state. System is recent releng/7 amd64. -- Andriy Gapon _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-stable To unsubscribe, send any mail to "[email protected]"