Re: [Fwd: Re: amd64 suspend/resume broken on current]

[CC added]

On Saturday 09 May 2009 09:55 am, Alexander Motin wrote:
> -------- Original Message --------
> Subject: Re: amd64 suspend/resume broken on current
> Date: Fri, 8 May 2009 21:52:45 +0200
> From: Guy Brand <[email protected]>
> Organization: Direction Informatique, Université de Strasbourg,
> France To: Alexander Motin <[email protected]>
> References: <[email protected]>
> <[email protected]> <[email protected]>
> <[email protected]> <[email protected]>
> <[email protected]>
>
> Guy Brand wrote:
>  > Alexander Motin wrote:
> > > Done. No firewire issue of course, but a kernel panic on
> > > resume. Bad karma since yesterday :-)
> >
> > Where is this panic happens now?
>
> Just after resuming:
>
>    Fatal trap 12: page fault while in kernel mode
>    ...
>    current process = 1415 (acpiconf)
>
> The backtrace says:
>
>    intr_execute_handlers() at intr_execute_handlers+0x21
>    lapic_handle_intr() at lapic_handle_intr+0x37
>    Xapic_isr1() at Xapic_isr1+0xa4
>
>    acpi_sleep_machdep() at acpi_sleep_machdep+0x3b2
>    acpi_EnterSleepState() at acpi_EnterSleepState+0x3fe
>    acpi_AckSleepState() at acpi_AckSleepState+0x163
>    devfs_ioctl() at devfs_ioctl_f+0x77
>    kern_ioctl() at kern_ioctl+0xb0
>    ioctl() at ioctl+0xfd
>    syscall() at syscal+0x246
>    Xfast_syscall() at Xfast_syscall+0xd0

So, that means the interrupt handler is executed *before* device is 
completely resumed.  In fact, the interrupts are not disabled for 
dcons(4), it seems:

#if 0 /* Let dcons(4) be accessed */
/* Stop interrupt */
        OWRITE(sc, FWOHCI_INTMASKCLR,
                        OHCI_INT_EN | OHCI_INT_ERR | OHCI_INT_PHY_SID
                        | OHCI_INT_PHY_INT
                        | OHCI_INT_DMA_ATRQ | OHCI_INT_DMA_ATRS
                        | OHCI_INT_DMA_PRRQ | OHCI_INT_DMA_PRRS
                        | OHCI_INT_DMA_ARRQ | OHCI_INT_DMA_ARRS
                        | OHCI_INT_PHY_BUS_R);

/* FLUSH FIFO and reset Transmitter/Reciever */
        OWRITE(sc,  OHCI_HCCCTL, OHCI_HCC_RESET);
#endif

I guess firewire(4) should differentiate suspend and shutdown 
properly.

Jung-uk Kim
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-current
To unsubscribe, send any mail to "[email protected]"