Re: 8-CURRENT Firewire
Julian Stecklina <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.firewire |
|---|---|
| Message-ID | <[email protected]> |
Sean Bruno <[email protected]> writes: > On Sun, 2009-07-05 at 23:03 +0200, Julian Stecklina wrote: >> Julian Stecklina <[email protected]> writes: >> >> >> 2. Can you boot with the firewire enabled in the BIOS and the following >> >> in loader.conf: >> >> firewire_load="NO" >> >> If you can boot this way, what happens when you: >> >> kldload sbp.ko >> >> http://os.inf.tu-dresden.de/~jsteckli/fbsd/sbp-after-boot.txt >> >> In summary: No devices are discovered, even though I have a DVD and a >> disk attached to the bus. >> >> Regards, > > Hrm ... I think that fwohci() or firewire() is getting stuck. > > Can you turn up debug and re-run your boot up sequence just like the > above dmesg? > > firewire_debug=3 > sbp_debug=3 I think I am too stupid to set these variables. I tried debug.firewire_debug=3 in loader.conf, but it doesn't work. After loading the modules they are always set to zero. Setting via sysctl doesn't work either, since they don't exist before loading firewire/sbp. So how do I set these? Regards, -- Julian Stecklina The day Microsoft makes something that doesn't suck is probably the day they start making vacuum cleaners - Ernst Jan Plugge _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-firewire To unsubscribe, send any mail to "freebsd-firewire-unsubscribe-h+KGxgPPiopAfugRpC6u6w@public.gmane.org"