Re: Typos in device attach output

On Tue, 2010-10-05 at 14:52 -0700, Bruce Cran wrote:
> Hi,
> 
> Every time I power on my laptop with Windows with a Firewire cable
> installed, I get the following output on the connected machine - I
> think it may be a bit excessive (though I realise the first lot is
> when the BIOS enables Firewire, the second from loading Windows), but
> reading it properly for the first time I noticed that one of the
> message seems to have a couple of typos:
> 
> fwohci: fwohci_intr_core: BUS reset
> fwohci: fwoci_intr_core: node_id=0x00000000, SelfID Count=3, non
> CYCLEMASTER mode
> firewire0: 2 nodes, maxhop <= 1 cable IRM irm(0) (me)
> firewire0: root node is not cycle master capable
> firewire0: bus manager 0
> fwohci0: too many cycle lost, no cycle master presents?
> fwohci0: fwohci_intr_core: BUS reset
> fwohci0:fwohci_intr_core: node_id=0x00000001, SelfID count=4, CYCLEMASTER mode
> firewire0: 2 nodes, maxhop <= 1 cable IRM irm(1) (me)
> firewire0: bus manager 1
> firewire0: New S400 device ID:384fc0003db91c90
> 
> I presume it should read "too many cycles lost, no cycle master present?"
> 

Correct.

Sean

_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-firewire
To unsubscribe, send any mail to "[email protected]"