Re: control of order of inet devices
Mehmet Erol Sanliturk <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.hardware,gmane.os.freebsd.current |
|---|---|
| Message-ID | <CAOgwaMtVZoHkSVAxUpp-kYAKxQ9E4ntYPA0xkahdyzK8gkFDJQ@mail.gmail.com> |
On Tue, Apr 16, 2013 at 11:36 AM, Brooks Davis <[email protected]> wrote: > On Tue, Apr 16, 2013 at 10:08:00AM -0700, Adrian Chadd wrote: > > Since people keep asking about this; maybe it's time we added a hint > > to the bus code that allows for the unit to be set based on the pci > > bus / slot / etc. > > I don't see how that would address Willy's request. Neither the unit > number or the if_index of an interface effects its order in > getifaddrs() output. > > With modern bus hierarchies, you probably don't want to use the unit > anyway as it loses too much information. Some along the lines of > Fedora's Consistent Network Device Naming would likely be more useful. > That would be fairly easy to implement. > > -- Brooks > Fedora is using eth0 , ... , eth9 , but FreeBSD is using em* , re* , .. names which is much better than Fedora ( or similar distributions ) approach . In eth0 , ... , usage , it is necessary to record MAC addresses of the NIC units ( because any name is not displayed like FreeBSD ) BEFORE starting an installation to isolate which one is referenced : Even this is not very useful sometimes because I am seeing they ( different Linux distributions ) are reporting MAC addresses differently for some NIC units , and no one of them is identical to others to number eth with existing NIC units ( for example , eth0 is not used for the same NIC by all the distributions , i.e. , there is no any standard numbering scheme ) . FreeBSD is using names ( Realtek , Intel , etc with other information also ) which is very easy to understand which NIC unit is referenced . I think , in FreeBSD , the problem may occur when all of the NIC units are the same model . For such cases , there is a necessity to display also slot / port information ( in that case MAC address is not showing slot / port information ) . Thank you very much . Mehmet Erol Sanliturk _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-hardware To unsubscribe, send any mail to "[email protected]"