Re: GPIO on FreeBSD 9.1
Anton Yuzhaninov <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.hardware |
|---|---|
| Organization | Vega |
| Message-ID | <[email protected]> |
On Thu, 07 Feb 2013 13:03:41, Alberto Mijares wrote: AM> I have a net4801 Soekris board. It has 12-pin GPIO interface. AM> AM> GENERIC kernel doesn't show any /dev/gpio* device. I tried including AM> AM> device gpio AM> AM> and I see the module with AM> AM> # kldstat -v | grep gpio AM> AM> but still no /dev/gpio* device. AM> AM> Could anyone point me to the steps to follow in order to enable such AM> interface? And taking the opportunity for a second shot, any AM> recommendation for a Perl module to work with? Try to add options CPU_GEODE to kernel config I don't have eny experience with Soekris, but /sys/i386/conf/NOTES said: CPU_GEODE is for the SC1100 Geode embedded processor And net4801 specification said about NSC SC1100 single chip processor _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-hardware To unsubscribe, send any mail to "[email protected]"