Re: Atheros AR9002U-2NG based TP-LINK TL-WN822N Ver:2.0 - adding support to FreeBSD

It's not uath. It's a different beast entirely.

Basically, it requires someone with USB clue to write the USB glue
between the ath(4) and ath_hal(4) code and the USB interface.

Look at what ath9k_htc implements. It uses most of ath9k, but it
implements a data/control pipe over USB and some commands to tell the
firmware to do things (like new/delete client, etc.)



-adrian

On 18 July 2013 08:39, CeDeROM <[email protected]> wrote:
> Hello :-)
>
> I have just bought USB WiFi b/g/n dongle from TP-LINK model TL-WN822B
> Ver:2.0 [1] which use following chipsets: Atheros AR9002U-2NG, Atheros
> AR7010, Atheros AR9287. It looks nice bacuse it cost ~20EUR it has
> external antennas and has very good opinions. Now, I start to think
> that finding Ver:3.0 based on RTL8192CU [2] might be a better
> choice..? Still I consider Atheros to be a better solution than
> Realtek..?
>
> I have made simple modification of /usr/src/sys/dev/usb/usbdevs and
> /usr/src/sys/dev/usb/wlan/if_uath.c to get it recognised, but uath
> driver seems to only support AR5005UG according to manpage. Is there
> any known driver to operate AR9002 chips?
>
> Here is what dmesg shows after my kernel modification/rebuild:
>
> ugen1.3: <ATHEROS> at usbus1
> uath0: <ATHEROS USB WLAN, rev 2.00/2.02, addr 3> on usbus1
> uath0: could not allocate USB transfers, err=USB_ERR_NO_PIPE
> device_attach: uath0 attach returned 12
>
> So it looks this driver will not operate with this chipset..?
>
> Any hints appreciated! :-)
> Tomek
>
> [1] http://wikidevi.com/wiki/TP-LINK_TL-WN822N_v2
> [2] http://wikidevi.com/wiki/TP-LINK_TL-WN822N_v3
>
> --
> CeDeROM, SQ7MHZ, http://www.tomek.cedro.info
> _______________________________________________
> [email protected] mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-usb
> To unsubscribe, send any mail to "[email protected]"