Re: Reset Problem with SATA Port Multiplier
Bob Bawn <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.hardware |
|---|---|
| Message-ID | <[email protected]> |
On Thu, Jul 25, 2013, Dieter BSD <[email protected]> wrote: > Sounds like FreeBSD is doing something bad to the pm, which Linux isn't > doing. Perhaps log the commands the OS sends to the controller (over the > network to a 2nd machine, or to a local disk not on a pm) and compare > BSD to Linux? Perhaps start logging when you get the first timeout, to > save hours of commands to wade through. Yes, that occurred to me. I was hoping to avoid learning how to build kernels with debug messages but I suppose it's a good skill to have. :-) > Alternately you could stare at the driver sources until enlightenment > occurs. I did a little of this and superficially it does seem like there could be differences between FreeBSD and Linux in the treatment of the mysterious 6th port (SEMB) on the 5-port multiplier. Hopefully, the logging you suggest will clarify the situation. Thanks for your help. _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-hardware To unsubscribe, send any mail to "[email protected]"