Re: HP DL380 Gen9 Dumb RAID controller
"Dmitriy Kulikov" <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.hardware |
|---|---|
| Message-ID | <7A0145BAA1694A6EBC256A6A290B0B82@dmitriypc> |
Hello! I have completely the same problem. Recently I asked a similar question in all possible ways (mailing lists, conference). https://forums.freebsd.org/threads/hp-gen9-arrays-support.52588/ I propose to share information when it appears. Best regards, Dmitriy -------------------------------------------------------------------------------- Sorry, I found a mismatch between the lists of supported controllers of driver "ciss". On the website of the developers stated that ciss supports new disk controlers of servers HP Gen 9 (H240ar, P440ar, etc.). But in the FreeBSD 10.1 documentation their support is not mentioned. Does FreeBSD 10 support new disk controlers (H240ar, P440ar) of servers HP Gen 9? http://cciss.sourceforge.net/ https://www.freebsd.org/releases/10.1R/hardware.html -------------------------------------------------------------------------------- ----- Original Message ----- From: "Wei Shan" <[email protected]> To: <[email protected]> Sent: Thursday, July 30, 2015 10:15 AM Subject: HP DL380 Gen9 Dumb RAID controller > Hi all, > > My company is currently looking to use FreeBSD ZFS for our major upcoming > project. Our hardware vendor is HP and we are looking to purchase HP DL380 > G9 servers. > > Previously we tested HP DL380 G9 servers with Smart array P420i. We were > not able to configure the RAID controllers in by-pass mode. Thus, we > configured each disk in RAID 0 config and we have multiple RAID 0 arrays > for each disk. > > However, I understand that ZFS needs to "see" and manage the disks directly > and not through RAID controllers. > > I have checked the FreeBSD hardware support matrix but HP H240 HBA > controller is not listed. Can someone recommend me a "dumb" controller > similar to H240 HBA which allows bypass mode so the ZFS can manage the > disks directly. > > HP has the following "dumb" controllers which supports pass through mode. > > 1. H240 > 2. H240ar > 3. H241 > > Any ideas and recommendations are greatly appreciated. We are under time > constraint so we are unable to buy 1 server to test. > > Thanks! > > -- > Regards, > Ang Wei Shan > _______________________________________________ > [email protected] mailing list > http://lists.freebsd.org/mailman/listinfo/freebsd-hardware > To unsubscribe, send any mail to "[email protected]" _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-hardware To unsubscribe, send any mail to "[email protected]"