Re: Dell Perc6/i
"Simon" <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.hardware |
|---|---|
| Message-ID | <[email protected]> |
Perc 6/i should work fine unless there is something very unique to your setup. Did you try 10.1? I have that on R710/Perc6/i RAID5 without problems. -Simon On Thu, 14 Apr 2016 11:39:20 -0400, Adonis Peralta wrote: >Hi all, >I'm having issues getting freebsd 10.3 to boot on my Dell R710 server which has a Perc6/i with the latest firmware. Install works fine but boot fails with gptboot failing or hanging and the kernel failing to load. I have 4 1TB disks set up on Raid0 and this fails. If I set them as individual disks then Freebsd successfully runs on that single disk. Is the Perc6/i a problem Raid card with FreeBSD? >Thanks, >Adonis >_______________________________________________ >[email protected] mailing list >https://lists.freebsd.org/mailman/listinfo/freebsd-hardware >To unsubscribe, send any mail to "[email protected]" _______________________________________________ [email protected] mailing list https://lists.freebsd.org/mailman/listinfo/freebsd-hardware To unsubscribe, send any mail to "[email protected]"