Re: Installing on zx6000
Marcel Moolenaar <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.ia64 |
|---|---|
| Message-ID | <[email protected]> |
On Jun 21, 2012, at 1:47 PM, Mike Burrell wrote: > FreeBSD/ia64 EFI boot, Revision 3.1 > Loading /boot/defaults/loader.conf > /boot/kernel/kernel data=0xfef1f8+0x82710 syms=[0x8+0x0xb1120+0x8+0xa62a9] > \ > Hit [Enter] to boot immediately, or any other key for command prompt. > Booting [/boot/kernel/kernel]... > Entering /boot/kernel/kernel at 0x9ffc000000010500... > > At that point, it either hangs indefinitely or does a hard reset after a > few seconds. No matter which version of FreeBSD I try to install, I've > never been able to get past the "Entering /boot/kernel/kernel at ..." Are you using a serial console? If not: start there. You may need to change hw.uart.console to match the hardware. By default it's set to the legacy PC COM1 port, which isn't there on HP. Normally this is not a problem, because the HCDP table is used -- but this means you need to use a serial console to begin with. FYI, -- Marcel Moolenaar [email protected] _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-ia64 To unsubscribe, send any mail to "[email protected]"