Re: UTF-8 problem in 8.0

On Fri, 01.01.2010 at 15:47:36 -0800, Derek Kulinski wrote:
> Hello,
> 
> After installing FreeBSD 8.0 I noticed that some characters aren't
> displayed correctly (it worked fine for 7.2).
> 
> Mainly the dash character is most noticeable (though it's possible
> it's more of them).
> 
> Example:
> env LANG=C man sh
> env LANG=pl_PL.UTF-8 man sh
> env LANG=en_US.UTF-8 man sh
> 
> The first command shows everything fine, the later two seem to show
> some unprintable character in place of every dash (i.e. in the second
> paragraph word "built-in", or the dashes that break up the words at
> the end of the line)

me too, though I'm only setting LC_CTYPE to de_DE.UTF-8 and I don't
always see it. It must be some combination of xterm/ssh and/or putty
that breaks this.

On the other hand, I thought there was a commit done, that would render
- (the dash) always as - (0x2d) so you can copy&paste the examples from
the manpage into your shell.

But perhaps I was just dreaming this up?

Bye,
Uli
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-i18n
To unsubscribe, send any mail to "[email protected]"