The CAPI device is not present or accessible

Hi, is just installed i4b, and  isdnconfig shows my card:

controller 0 = {
  Layer 1:
    description : HFC-2BDS0 128K PCI ISDN adapter
    type        : passive ISDN (Basic Rate, 2xB)
    channels    : 0x3
    serial      : 0xabcd
    power_save  : on
    dialtone    : enabled
    attached    : yes
    PH-state    : G3: Active
  Layer 2:
    driver_type : DRVR_DSS1_NT
}

But when i try to start callweaver with the chan_capi.callweaver, i get 
this:

 [chan_capi.so] => (Common ISDN API 2.0, CAPI2.0, for OpenPBX)
  == Parsing '/usr/local/etc/callweaver/capi.conf': Parsing 
/usr/local/etc/callweaver/capi.conf - Found
Nov 11 19:45:04 WARNING[23320]: chan_capi.c:1434 capi_application_alloc: 
The CAPI device is not present or accessible!
Nov 11 19:45:04 WARNING[23320]: chan_capi.c:8357 load_module: CAPI is 
disabled!
Nov 11 19:45:04 WARNING[23320]: loader.c:348 __load_resource: 
chan_capi.so: load_module failed, returning -1
Nov 11 19:45:04 WARNING[23320]: loader.c:488 load_modules: Loading 
module chan_capi.so failed!

What does the "capi20_is_installed" function check to tell me: "No Chapi"
The capitest command is working

Kristijan
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-isdn
To unsubscribe, send any mail to "[email protected]"