Re: system freeze on kldload i4b

Thanks, it works !

I did not set the appropriate SYSDIR

kind regards,
sjonnie
#####
ihfc0: <HFC-2BDS0 128K PCI ISDN adapter> port 0xec00-0xec07 mem 
0xfebffc00-0xfebffcff irq 10 at device 8.0 on pci1
ihfc0: Attaching I4B controller 0.
ihfc0: Creating /dev/ihfc0.X.
i4btel: 8 ISDN telephony interface device(s) attached
i4b: ISDN call control device attached
capi: CAPI call control device attached, v2.12
i4bipr: 8 IP over raw HDLC ISDN device(s) attached
i4bctl: ISDN system control port attached
i4brbch: 8 raw B channel access device(s) attached
i4btrc: 64 ISDN trace device(s) attached
i4bisppp: 8 ISDN SyncPPP device(s) attached
i4bing: 8 i4b NetGraph ISDN B-channel device(s) attached
iloop0: I4B Loopback device (attached)
i4b: Attaching I4B controller 63.

Hans Petter Selasky wrote:
> On 09/17/15 08:48, J.L. te Linde wrote:
>> Hi,
>>
>> Previous FreeBSD-versions (2011, freebsd-7*)  worked fine with isdn4bsd:
>> thanks !!
>> Using HFC-2BDS0 128K PCI ISDN adapter
>> The system was used as -headless- answering machine.
>>
>> In 2014 , after updating to 9-series (just using a vanilla kernel), the
>> system freezes when loading i4b
>> No debug info.
>>
>> Yesterday , I've downloaded a fresh version of i4b (svn)
>> Clean compile!
>> (apart from some manpages decode.gz, file not found)
>> And again the system immediately freezes after kldload i4b.
>> No debug info.
>>
>> FreeBSD 9.3-RELEASE-p24 #0: Sat Aug 22 01:54:44 UTC 2015
>>
>> any ideas ?
>
> Hi,
>
> How did you build I4B?
>
> Did you set the SYSDIR for the kernel sources?
>
> If you load w/o PCI adapter, does it freeze then too?
>
> --HPS
>
>

_______________________________________________
[email protected] mailing list
https://lists.freebsd.org/mailman/listinfo/freebsd-isdn
To unsubscribe, send any mail to "[email protected]"