Re: ISDN4BSD / ihfc0 in NT-mode setup
Hans Petter Selasky <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.isdn |
|---|---|
| Message-ID | <[email protected]> |
On Wednesday 08 November 2006 15:40, Daniel Hartmeier wrote: > On Wed, Nov 08, 2006 at 03:12:33PM +0100, Hans Petter Selasky wrote: > > You need to configure "isdnd" before you can use "isdnphone". Try running > > "capitest -u 0 -i 1 -o 1" instead. It seems like you have configure the NT-side to P2P mode. Try running "isdnconfig -u 0 -p DRVR_DSS1_NT". Then "cat /dev/i4b > /dev/null &" or run "capitest -u 0 -i 1 -o 1". Then pickup the phone. Have "isdndecode" running concurrently. Do you hear the dialtone ? > There is still no tone one the phone and it still produces the > "No connection" message, but I hope the output above might tell > what is wrong. > > > If the messages you get use TEI 0 then it is P2P_NT you need to setup. > > They do, right? The message "TEI Identity message = REQUEST" means that Point to Multipoint mode is used. > > > "isdntest" can do some basic testing, but "capitest" is better. > > "isdntest" is not installed by default. > > Does the output above look ok? Does it mean the cabling is fine? I am not sure if the cable is fine, but at least you receive messages. You can double check the crossover with "man ihfc". > > Next thing I need to do is set up isdnd, and then I can use capitest > to dial from the FreeBSD box to the phone (or does capitest itself > not require isdnd)? "capitest" does not require "isdnd". --HPS _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-isdn To unsubscribe, send any mail to "[email protected]"