Re: ndisgen and 5-STABLE
sebastian ssmoller <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
On Fri, 1 Jul 2005 15:07:24 -0600 (MDT) Warren Block <[email protected]> wrote: > With ndiscvt, it was possible to build a working ndis module for my > Thinkpad T42 with Intel 2100 802.11b card. > > Now, ndisgen has been merged into 5-STABLE, and ndisgen runs and > reports "conversion successful." It builds W70N51_SYS.ko (and .o) in > the current directory. > > Copying W70N51_SYS.ko to /boot/kernel and the kldloading that file > results in an almost-working setup. kldload never exits, but ndis0 > does show up in ifconfig. > > It even works, until a program tries to down the interface. Then it > never exits, either. > > This is on 5-STABLE as of yesterday. Any suggestions? same situation here on recent -CURRENT (same card and driver) .... regards, seb -- "Perfection is achieved, not when there is nothing left to add, but when there is nothing left to take away." --- Antoine de St. Exupery, Wind, Sand, and Stars, 1939 _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"