Re: Broken support for 3Com 3c575C Fast Etherlink XL?
Jens Andre Griepentrog <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
> Sun, 12 Jun 2005 00:32:47 -0600 (MDT) > "M. Warner Losh" <[email protected]> wrote: > > In message: <[email protected]> > Chris Buechler <[email protected]> writes: > : On 5/17/05, Jens Andre Griepentrog <[email protected]> wrote: > : > > : > Hello, > : > > : > I have upgraded my Compaq Armada 1750 notebook to FreeBSD 5.4-RELEASE. > : > In contrast to the old 5.1-RELEASE, now the support for my 3Com 3c575C > : > Fast Etherlink XL cardbus network device seems to be broken. > : > It will not be initialized as you can see in the dmesg output below: > : > > : <snip> > : > uhci0: <Intel 82371AB/EB (PIIX4) USB controller> port 0x2000-0x201f irq 11 at device 7.2 on pci0 > : <snip> > : > xl0: <3Com 3c575C Fast Etherlink XL> port 0x1100-0x117f mem 0x88000000-0x8800007f,0x88000080-0x880000ff irq 11 at device 0.0 on cardbus0 > : > : > : My 3c575C (xl) works fine on 5.4. My first guess would be the USB and > : NIC using the same IRQ is causing some problems. > > No. That's not the problem. It is more likely a resource problem for > memory... > > Warner > It seems to me that FreeBSD-5.4 has not only problems with the 3c575C card attached to my Compaq Armada 1750. I also tried out a D-Link DFE-690TXD network card on this notebook, again without success. At work both cards work fine on an Acer TravelMate 630 notebook and FreeBSD-5.4! Best regards, Jens A. Griepentrog _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"