Re: FreeBSD6, FSC Lifebook E8010, Xorg

You can try by issuing:

shell# kldload agp

(check your ttyv0 console or /var/log/messages for some info)

If it OK, you can use the agp module by putting *agp_load="YES"* on 
/boot/loader.conf
or recompile the kernel back by inserting *device agp* on your kernel 
configuration.


----- Original Message ----- 
From: "Rainer Duffner" <[email protected]>
To: "Vitaly Markitantov" <[email protected]>
Cc: <[email protected]>
Sent: Tuesday, July 19, 2005 4:16 PM
Subject: Re: FreeBSD6, FSC Lifebook E8010, Xorg


> Vitaly Markitantov wrote:
>
>>On 16/07/05, Rainer Duffner <[email protected]> wrote:
>>
>>>Hi,
>>>I've got said Lifebook, with SXGA+ screen.
>>>When I run the 915resolution-program and try to change the Mode "3c" to
>>>1440x1050, it will not complain, but the mode will still be the old one
>>>when I list the modes and resolutions again.
>>>So Xorg only runs with 1280x1024, which is unusable.
>>>Also, when I start X, it complains about missing agpgart-device:
>>>(EE) GARTInit: Unable to open /dev/agpgart (No such file or directory)
>>>(WW) I810(0): /dev/agpgart is either not available, or no memory is
>>>available
>>>for allocation.  Using pre-allocated memory only.
>>>(II) I810(0): Checking Lid status enabled
>>>Is there a reason why it will not detect my I855-chipset?
>>>What can I do?
>>>
>>
>>What about Driver "vesa"  in your xorg.config?
>>
>>
>
>
> It doesn't help.
>
> Shouldn't FreeBSD find some sort of agp-device during boot-up?
>
>
>
> Rainer
> _______________________________________________
> [email protected] mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
> To unsubscribe, send any mail to "[email protected]" 

_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"