Re: HP nx9005 and Netgear WG511T
"M. Warner Losh" <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
In message: <[email protected]> Kirill Ponomarew <[email protected]> writes: : On Sat, Aug 20, 2005 at 06:10:31PM +0200, Dylan Wylie wrote: : > >You're able to run it on HP Compaq nx9005 ? : > Older compaq's; one pressario1600 and a E500 : > > : > >I'm afraid there is something more broken than ath driver. After : > >unplugging the card, I'm also getting on console: : > > : > >ath0: ath_reset: unable to reset hardware; hal status 3229953940 : > >ath0: hardware error; resetting : > >ath0: ath_chan_set: unable to reset channel 6 (2437 Mhz) : > >ath0: ath_reset: unable to reset hardware; hal status 3229953940 : > >ath0: detached : > > : > >-Kirill : > > : > So,what cardbus hardware for an nx9005? : > for presario 1600 it's: : > cbb0: <TI1211 PCI-CardBus Bridge> at device 10.0 on pci0 : > cardbus0: <CardBus bus> on cbb0 : > pccard0: <16-bit PCCard bus> on cbb0 : : cbb0: <O2Micro OZ6933 PCI-CardBus Bridge> mem 0x80000000-0x80000fff irq 11 at device 10.0 on pci0 : cbb0: Reserved 0x1000 bytes for rid 0x10 type 3 at 0x80000000 : cardbus0: <CardBus bus> on cbb0 : pccard0: <16-bit PCCard bus> on cbb0 : : cbb1: <O2Micro OZ6933 PCI-CardBus Bridge> at device 10.1 on pci0 : cbb1: Lazy allocation of 0x1000 bytes rid 0x10 type 3 at 0x80001000 : cardbus1: <CardBus bus> on cbb1 : pccard1: <16-bit PCCard bus> on cbb1 : pcib0: matched entry for 0.10.INTA (src \\_SB_.PCI0.ISA_.LNKF:0) : pcib0: slot 10 INTA routed to irq 11 via \\_SB_.PCI0.ISA_.LNKF : cbb1: [MPSAFE] : : > I am still curious if you can get the card to work on _any_ other machine? : : Yes, the card works perfect on all another machines. : : > The messages on uplugging would't realy worry me actually; it does : > detach eventualy. Could be wrong though. Perhaps some-one else : > can enlighten us on the ghz stuff: does it have any 'real' value, : > or is it just some hardware string? Please send me the full dmesg output. It may be a cbb problem. Warner _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"