RE: D-Link DWL-G650 H/W Ver.: C3

Ok, I downloaded the C driver from Dlink Site, and

ndiscvt -i NetA3AB.inf -s A3AB.sys -o ndis_driver_data.h

Copied the file into /usr/src/sys/modules/if_ndis and from this directory
make && make install

Then kldload if_ndis ; the Act led blinks but on the dmesg appears

carbus0: <network, ethernet> at device 0.0 (no driver attached)

ifconfig doesn’t show anything.





Ing. Harry Barrantes
Diotronic de Centroamérica S.A.
Ingeniería en Redes, Electrónica e Internet
Móvil: (506) 841-5957
Oficina: (506) 226-7406
Email: [email protected]
Web Site: www.diotronic.co.cr
San José, Costa Rica 
-----Mensaje original-----
De: Daniele Pilenga [mailto:[email protected]] 
Enviado el: Viernes, 21 de Octubre de 2005 10:32 p.m.
Para: [email protected]
Asunto: Re: D-Link DWL-G650 H/W Ver.: C3

Harry Barrantes wrote:
> Thanks Daniele, I tried your steps, check this:
> 
> daemon# ndiscvt -i NetA3AB.inf -s A3AB.sys -o ndis_driver_data.h
> ndiscvt: line 422: "D:ARAI(A;;GA;;;BA)(A;;GA;;;SY)(A;CI;GA;;;IU)": syntax
> error.
> daemon#
> 
> I'm running FBSD 6 RC1

Mmh... that's strange, it seems there is a problem with you .inf file. I 
don't think that 6.0RC1 is much different from my 5.4, but have you 
tried downloading the Windows' drivers directly from the d-link site?

Ciao,
D.

_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"