Re: Repost: DHCP failing with WiFi after 6.0 upgrade

"Kevin Oberman" <[email protected]>
Newsgroups gmane.os.freebsd.devel.mobile
Message-ID <[email protected]>
> Date: Fri, 2 Dec 2005 23:50:21 -0500
> From: Jesse Sheidlower <[email protected]>
> 
> On Fri, Dec 02, 2005 at 09:51:59AM -0800, Kevin Oberman wrote:
> > > Date: Fri, 2 Dec 2005 07:49:33 -0500
> > > From: Jesse Sheidlower <[email protected]>
> 
> [...]
> 
> > > My biggest problem is that I can't seem to get DHCP to work with my
> > > wireless card. I have an Orinoco Gold 802.11b card that's always worked
> > > fine; I'm about to replace it with something else for 802.11g with a
> > > new WAP.
> 
> [...]
> 
> > Under V6, you must explicitly specify the WEP transmit key index:
> > ifconfig wi0 ssid jesterWAP wepmode on weptxkey 1 wepkey 1:0x[DELETED]
> 
> Many thanks! This is all it took. At least, with this I was able
> to get a DHCP lease.
> 
> I expect I'm about to expose my cluelessness, but even after getting
> the lease--which, obviously, required going over the WAP to my router--
> I still can't connect anywhere. My wi0 ifconfig looks like:
> 
> wi0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
>         inet6 fe80::202[DELETED] prefixlen 64 scopeid 0x3
>         inet 192.168.1.105 netmask 0xffffff00 broadcast 192.168.1.255
>         ether 00:02[DELETED]
>         media: IEEE 802.11 Wireless Ethernet autoselect (DS/11Mbps)
>         status: associated
>         ssid jesterWAP channel 6 bssid 00:06:[DELETED]
>         stationname "FreeBSD WaveLAN/IEEE node"
>         authmode OPEN privacy MIXED deftxkey 1 wepkey 1:104-bit txpowmax 100
>         bintval 100
> 
> after getting my DHCP lease. But I am unable to ping the router, or
> the WAP, or run any traceroutes, or anything else over the network.
> GNOME's "Connection Properties" applet shows packets received but
> nothing sent, FWIW. I have no problem using the Ethernet interface.

This is most likely the default route. DHCP will set it, but it will
not replace a default that is already there if it was not set by
dhclient. .

Try either 'router delete default' or 'route flush' before running
dhclient. If you already have dhclient running, I'd 'killall dhclient'
and then restart it.

> To address the other sub-thread: Are there no PC cards that
> will work with 802.11g on a ThinkPad X23? I don't mind getting
> an IBM-branded one, if that's what it takes, but this is a
> four-year-old computer. There was some conflicting information
> upthread about whether there are Atheros-based cards that will
> work in some circumstances, or what.

Last word from Lenovo is that no 802.11G cards are supported for the T30
and I suspect thats the T23, being even older is in the same state. I
understand that it might be possible to hack BIOS to get around this,
but I don't have any details. Of course, you can get a Cardbus b/g card
(or a/b/g) and use that. I'd suggest Athros based, for the obvious
reasons. 
-- 
R. Kevin Oberman, Network Engineer
Energy Sciences Network (ESnet)
Ernest O. Lawrence Berkeley National Laboratory (Berkeley Lab)
E-mail: [email protected]			Phone: +1 510 486-8634
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.