Xircom Driver Issue
Lakshminarayanan Sundareswaran <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
Hi All, I'm new to FreeBSD. I recently installed FreeBSD 6.0 in my Laptop. The installation completed successfully, but I was not able to configure the network. Later on I found that my xe driver was not loading properly. The xe driver is compiled into the kernel. During boot I'm getting the following error message: module_register: module pccard/xe already exists! Module pccard/xe failed to register already exists ed1: <Xircom 10/100 Network PC Card> at port 0x100-0x10f iomem 0x88000000-0x88000fff irq 11 function 0 config 1 on pccard0 device _attach: ed1 attach returned 6 I'm using a Xircom (XE2000) 32bit PCMCIA 10/100 Ethernet only card. Can anyone pls help mein resolveing the issue? regds csnarain _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"