Re: Xircom Driver Issue
Scott Mitchell <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
On Tue, Dec 06, 2005 at 11:28:03PM -0800, Lakshminarayanan Sundareswaran wrote: > Hi All, > > I'm new to FreeBSD. I recently installed FreeBSD 6.0 in my Laptop. The > installation completed successfully, but I was not able to configure the > network. Later on I found that my xe driver was not loading properly. The xe > driver is compiled into the kernel. During boot I'm getting the following > error message: > > module_register: module pccard/xe already exists! > Module pccard/xe failed to register already exists > > ed1: <Xircom 10/100 Network PC Card> at port 0x100-0x10f iomem > 0x88000000-0x88000fff irq 11 function 0 config 1 on pccard0 > device _attach: ed1 attach returned 6 > > I'm using a Xircom (XE2000) 32bit PCMCIA 10/100 Ethernet only card. > > Can anyone pls help mein resolveing the issue? I don't think I can help with the real problem, but this is nothing to do with xe - your card is a CardBus device that wants to work with the ed driver. That said, I know there are some outstanding annoyances with xe I need to look at... Scott -- =========================================================================== Scott Mitchell | PGP Key ID | "Eagles may soar, but weasels Cambridge, England | 0x54B171B9 | don't get sucked into jet engines" scott at fishballoon.org | 0xAA775B8B | -- Anon _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"