Re: pcm0 not responding on -CURRENT...

On Sun, 2002-07-07 at 21:08, Sean Chittenden wrote:
> Anyone have any ideas why I'd be able to load snd_pcm.ko, then have it
> stop responding as soon as I try and play a sound through it?  The dev
> entry disappears after the 1st time I try and use it.  I haven't
> recompiled my kernel, the only thing I've done recently was use
> bsd-airtools (which I think did something someplace...).
> 
> Preloaded elf module "/boot/kernel/snd_pcm.ko" at 0xc047b15c.
> ...
> pcm0: <ESS Technology Maestro3> port 0xd800-0xd8ff mem 0xfaffe000-0xfaffffff irq 5 at device 8.0 on pci0
> ...
> pcm0:play:0: play interrupt timeout, channel dead
> pcm0:play:0: play interrupt timeout, channel dead
> pcm0:play:0: play interrupt timeout, channel dead

I get this, too from time to time on my DI 8100.  However, if I reboot,
the problem is usually solved, so it's something intermittent.  I have
noticed since the latest maestro3 update the other day, I haven't seen
the problem. 

> ...
> 
> The only other thing that I can note of any significance for this
> laptop is that on shutdown, this laptop will normally freeze hard
> after it says "unloading vnlru" or some such.  Anyone have any ideas?
> 
> My best/wild/flailing guess is that one of the airtools did something
> to my sound card... but I don't know how to reset the hardware config
> for the snd card.  eh?  -sc

Could be.  While I have a wireless card for this laptop, I do not use
bsd-airtools (yet).

Joe

> 
> -- 
> Sean Chittenden
> 
> To Unsubscribe: send mail to [email protected]
> with "unsubscribe freebsd-mobile" in the body of the message
> 
-- 
PGP Key : http://www.marcuscom.com/pgp.asc


To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message