Re: Problem upgrading Tosh from FBSD4 to FBSD5
Bruno Ducrot <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
On Wed, Dec 14, 2005 at 09:05:13PM -0500, Tuc at T-B-O-H wrote: > Hi, > > Following http://www.freebsd.org/releases/5.3R/migration-guide.html and > I ran into a problem. When I boot to single user mode It sticks and can't get > farther. I'm typing this by hand.... > > atapci0: <Intel PIIX4 UDMA33 controller> port 0x376,0x170-0x177,0x3f6,0x1f0-0x1f7 at device 5.1 on pci0 > atapci0: Lazy allocation of 0x10 bytes rid 0x20 type 4 at 0 > ata0: channel #0 on atapci0 > atapci0: Reserved 0x8 bytes for rid 0x10 type 4 at 0x1f0 > atapci0: Reserved 0x1 bytes for rid 0x14 type 4 at 0x3f6 > ata0: reset tp1 mask=03 ostat0=50 ostat1=00 > ata0-master: stat=0x50 err=0x01 lsb=0x00 msb=0x00 > ata0-slave: stat=0x00 err=0x01 lsb=0x00 msb=0x00 > ata0: reset tp2 stat0=50 stat1=00 devices=0x1<ATA_MASTER> > ata0: [MPSAFE] > ata1: channel #1 on atapci0 > atapci0: Reserved 0x8 bytes for rid 0x18 type 4 at 0x170 > atapci0: Reserved 0x1 bytes for rid 0x1c type 4 at 0x376 > > What now? Its a brick! > I had a similar problem to yours with a toshiba sattelite some times ago, but under FreeBSD 5.X. I don't have that laptop anymore. It was possible to go further after disabling eisa support, but I don't remember exactly which hint was needed though. It should be something like this: hint.eisa.0.disabled="1" -- Bruno Ducrot -- Which is worse: ignorance or apathy? -- Don't know. Don't care. _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"