Re: PCMCIA Surecom EP-427X

At 10:25 PM 7/9/2002 -0600, you wrote:
>Any chance you could update to a -stable kernel and try again?  Also,
>can you include a dmesg?  Chances are this is the "ToPIC bug" that I
>fixed recently.


Warner,

I hope this could tell something to you...
I send the "dmesg" and some messages for you.

 >>> dmesg :

[start]

Copyright (c) 1992-2002 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
         The Regents of the University of California. All rights reserved.
FreeBSD 4.6-RELEASE #0: Wed Jul 10 14:48:55 WIT 2002
     [email protected]:/usr/obj/usr/src/sys/GENERIC
Timecounter "i8254"  frequency 1193182 Hz
CPU: Pentium III/Pentium III Xeon/Celeron (696.58-MHz 686-class CPU)
   Origin = "GenuineIntel"  Id = 0x686  Stepping = 6
   Features=0x383f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE>
real memory  = 134152192 (131008K bytes)
avail memory = 125628416 (122684K bytes)
Preloaded elf kernel "kernel" at 0xc04d0000.
Pentium Pro MTRR support enabled
md0: Malloc disk
Using $PIR table, 7 entries at 0xc00fdf50
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Intel 82443BX (440 BX) host to PCI bridge> on motherboard
pci0: <PCI bus> on pcib0
pcib1: <Intel 82443BX (440 BX) PCI-PCI (AGP) bridge> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
pci1: <ATI Mobility-1 graphics accelerator> at 0.0 irq 10
pci_cfgintr_linked: linked (60) to hard-routed irq 10
pci_cfgintr: 0:4 INTA routed to irq 10
pcic0: <TI PCI-1420 PCI-CardBus Bridge> irq 10 at device 4.0 on pci0
pcic0: PCI Memory allocated: 0x44000000
pcic0: TI12XX PCI Config Reg: [speaker enable][pwr save][FUNC pci int + CSC 
serial isa irq]
pccard0: <PC Card bus (classic)> on pcic0
pci_cfgintr_linked: linked (61) to hard-routed irq 10
pci_cfgintr: 0:4 INTB routed to irq 10
pcic1: <TI PCI-1420 PCI-CardBus Bridge> irq 10 at device 4.1 on pci0
pcic1: PCI Memory allocated: 0x44001000
pcic1: TI12XX PCI Config Reg: [speaker enable][pwr save][FUNC pci int + CSC 
serial isa irq]
pccard1: <PC Card bus (classic)> on pcic1
isab0: <Intel 82371AB PCI to ISA bridge> at device 7.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel PIIX4 ATA33 controller> port 0x1050-0x105f at device 7.1 on 
pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
uhci0: <Intel 82371AB/EB (PIIX4) USB controller> irq 10 at device 7.2 on pci0
uhci0: Could not map ports
device_probe_and_attach: uhci0 attach returned 6
chip1: <Intel 82371AB Power management controller> port 0x1040-0x104f at 
device 7.3 on pci0
pci0: <unknown card> (vendor=0x1013, dev=0x6005) at 8.0 irq 5
pci0: <unknown card> (vendor=0x11c1, dev=0x0450) at 16.0 irq 10
orm0: <Option ROMs> at iomem 0xc0000-0xcffff,0xe4000-0xe7fff on isa0
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model IntelliMouse, device ID 3
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
sio0: configured irq 4 not in bitmap of probed irqs 0
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 8250
sio1: configured irq 3 not in bitmap of probed irqs 0
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: Generic chipset (EPP/NIBBLE) in COMPATIBLE mode
plip0: <PLIP network interface> on ppbus0
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ppi0: <Parallel I/O> on ppbus0
ad0: 9590MB <FUJITSU MHM2100AT> [19485/16/63] at ata0-master UDMA33
acd0: CDROM <TOSHIBA CD-ROM XM-7002Bc> at ata1-master PIO4
Mounting root from ufs:/dev/ad0s1a
pccard: card inserted, slot 1
pccard: card removed, slot 1
pccard: card inserted, slot 1
ed1 at port 0x320-0x33f irq 10 flags 0x30000 slot 1 on pccard1
ed1: address 21:02:00:ff:15:12, type NE2000 (16 bit)
ed1: detached
pccard: card removed, slot 1
pccard: card inserted, slot 1
ed1 at port 0x320-0x33f irq 10 flags 0x30000 slot 1 on pccard1
ed1: address 21:02:00:ff:15:12, type NE2000 (16 bit)
ed1: detached
pccard: card removed, slot 1

[end]


 >>> Following is some messages at the screen / monitor when I inserted / 
removed the card :

[...]
pccard: card inserted, slot 1
Jul 10 15:01:42 mobile pccardd[49]: Card "PCMCIA"("100BASE") [(null)] 
[(null)] matched "PCMCIA" ("100BASE") [(null)] [(null)]
Jul 10 15:01:42 mobile pccardd[49]: Found existing driver (ed) for PCMCIA
Jul 10 15:01:42 mobile pccardd[49]: Using I/O addr 0x320, size 32
Jul 10 15:01:42 mobile pccardd[49]: Setting config reg at offs 0x3c0 to 
0x47, Reset time = 50 ms
Jul 10 15:01:47 mobile pccardd[49]: Assigning I/O window 0, start 0x320, 
size 0x20 flags 0x5

ed1 at port 0x320-0x33f irq 10 flags 0x30000 slot 1 on pccard1
ed1: address 01:02:00:ff:15:12, type NE2000 (16 bit)
Jul 10 15:02:02 mobile pccardd[49]: ed1: PCMCIA (100BASE) inserted.
ed1: detached
pccard: card removed, slot 1
Jul 10 15:02:07 mobile pccardd[49]: ed1: PCMCIA (100BASE) removed.
[...]


The message :

Jul 10 15:01:47 mobile pccardd[49]: Assign ed1, io 0x320-0x33f, mem 0x0, 0 
bytes, irq 10, flags 30000

is the last message before the system FREEZZ.

Thanks

Regards,

Tonka






To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message