Re: ral/wpa_supplicant drops after successful WPA negotiation?

On 02/03/06, Peter de Rooij <[email protected]> wrote:
> <snip>
> So I got a new card (partly because it's flaky under WinXP as well),
> atheros based.
> Added if_ath_load=YES to load.conf, and the card is detected.  Beyond
> that, alas still no connection. In fact, the connection is sometimes
> associated, but never even gets to EAPOL negotiation; time-out before
> then.  The naked eye suggests it immediately drops from "UP" back to
> "DOWN"; in fact I also saw several "ath0: 2 link states coalesced"
> messages.
> <snip>
> [...] is this the bug with the unexpected timer trigger after all?

In fact, the link kept going down even without wpa.  Every few seconds
or so.  ping showed a 7% packet loss.  And under XP it still worked
reasonably well.

Anyway, I still don't know what the problem was, but it disappeared
when replacing the AP (the old one kept losing all settings from flash
-- I decided it was at the end of its physical life).  The new one
connected in one go (maybe 3 minutes, including reboot to see if
rc.conf and looader.conf changes worked).

Let me know if there's interest to dig deeper -- the symptoms aren't
all consistent with an AP failure.  My curiosity may prod me to do so
in the interest of improved code.

Cheers, Peter
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"