Re: ath0: unable to attach hardware; HAL status 13
Eric Anderson <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
Sam Leffler wrote: > Kevin Kramer wrote: >> I have a Dell Latitude D820 with an Atheros mini-pci express b/g card. >> I'm getting these errors when loading the drivers: >> >> ath0: <Atheros 5424> mem 0xdcff0000-0xdcffffff irq 17 at device 0.0 on >> pci12 >> ath0: Reserved 0x10000 bytes for rid 0x10 type 3 at 0xdcff0000 >> ioapic0: routing intpin 17 (PCI IRQ 17) to vector 50 >> ath0: [MPSAFE] >> ath0: unable to attach hardware; HAL status 13 >> device_attach: ath0 attach returned 6 >> >> It's being detected as a 5424, but it is actually a 2424. (It does b/g, >> not a/b/g) >> >> An a/b/g card (5424) works fine using the same config. >> >> Here is a link to some additional debug info, let me know if I can help >> further. >> >> http://users.centtech.com/~kramer/atheros/ > > Don't know about a 2424; the 5424 should work though the driver may need > a workaround for a pci-express reset issue. Did you swap this card in > or did it come from dell? I've been slow to get up to speed on the > pci-express parts but they definitely work with the hal in cvs. > > I'll check. > > Sam Thanks Sam. The 5424's indeed work. The 2424 is the same except it is b/g only, not a/b/g. Let us (kramer or I) know if we can provide any addition debug info/patch testing/etc. Eric -- ------------------------------------------------------------------------ Eric Anderson Sr. Systems Administrator Centaur Technology Anything that works is better than anything that doesn't. ------------------------------------------------------------------------ _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"