hostap WEP SMC2632
"Peter J. Blok" <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
Hi, I have seen a lot of messages about wireless cards working and not working with hostap. I have a SMC2602 which is a SMC2632 in a PCI card. Works fine. When I setup hostap without WEP and use netgraph bridging it works, but is not very stable. I'm getting timeout messages and then the connection stops. When I define WEP, my laptop (running W2K) is not able to setup a connection. The firmware of the laptop SMC2632 card is the same. However WEP in adhoc mode works fine. This applies for both 40 and 128 bit. I am running FreeBSD 4.6-RELEASE-p2 Below the dmesg output. Jul 17 10:33:21 fwgw /kernel: wi0: <PRISM2STA WaveLAN> port 0xd000-0xd03f,0xd400-0xd47f mem 0xe7000000-0xe7000fff irq 12 at device 9.0 on pci0 Jul 17 10:33:21 fwgw /kernel: wi0: 802.11 address: 00:04:e2:07:db:dd Jul 17 10:33:21 fwgw /kernel: wi0: using RF:PRISM2 MAC:HFA3841 CARD:HWB3163 rev.A Jul 17 10:33:22 fwgw /kernel: wi0: Intersil Firmware: Primary 0.03.00, Station 0.08.03 I was told the same firmware for DLink and netgear can be used for the SMC cards too. Does somebody have hostap working with WEP and a card with the same firmware? Thx, Peter To Unsubscribe: send mail to [email protected] with "unsubscribe freebsd-mobile" in the body of the message