Re: Problem (maybe a solution) loading iwi firmware: firmware_get: failed to load firmware image iwi_bss
John Baldwin <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
On Monday 31 July 2006 18:07, Erik Nørgaard wrote: > John Baldwin wrote: > > 2) Try adding 'hw.pci6.0.10.INTA.irq=5' to /boot/loader.conf and seeing if > > that changes iwi0 to using IRQ 5 and fixes your problem. > > I tried and also with hw.pci6.10.0.INTA.irq=5 (looking at the pciconf > output, I thought this might be what you meant, or should it be in hex? > pci6.0a.0?), but this makes no difference and is ignored. And the device > still gets irq 10. Sorry, 'hw.pci6.10.INTA.irq=5'. > I was thinking: Is there a way to completely disable a device such that > it gets no irq, address or anything else assigned? > > Some of the devices I will never use, or at least not in near future, > such as the firewire, the memory card reader and USB2, because I have no > such devices to attach. And ISA, isn't that legacy? > > Maybe this could reduce noise? > > Of course this is not the perfect solution, but it is workable for now. None of that would buy you anything. It doesn't cost anything for devices to have resources assigned. -- John Baldwin _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"