Battery on Clevo M120 W

Hello,

I don't know wether it is the right place to post this; i first tried 
freebsd-acpi, but didn't get any response: maybe I did something wrong...
Well: I'm was running FreeBSD 5.4 on my laptop without any main problem 
related to acpi. But since I upgraded to 6 - Stable, I miss the battery 
life status, which is very annoying... Since it worked on 5.4, it might 
not be an ASL problem (anyway: it tried acpidump & ald *.dump and only 
got 2 minor errors). Does someone experience a similar problem ?
Related to the battery: the handbook provided by the vendor describes 
the battery as a smart batt, although demsg shows battery0: <ACPI 
Control Method Battery>. Is it possible to force the load of sm_batt ?

Secondly: i'm getting a wrong acpi-line status every time I'm rebooting. 
After unplugging the ac adapter, and reconnecting it, everything seems 
to work fine. Perhaps the adapter is not ready when it's first beeing 
tested ? Is there any way to force a new status-init a bit later ?

Any help or comments woudl be greatly appreciated. I find it to stupid 
to leave FreeBSD because of a batt problem; so I ready to read-and-do 
everything's neccessary to get it working again. If required, I can post 
system log or acpi messages.

Thanks for help,

Felix
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"