Re: netgear wg511t pccard on Clevo m120_w
"felix.schalck" <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
Lars Engels wrote:
> On Sat, Oct 07, 2006 at 06:05:41PM +0200, felix.schalck wrote:
>
>> Hi,
>>
>> I'm trying to get the Netgear wg511t working under 6.x.
>> Card works well under linux.
>> Dmesg shows:
>> --------
>> #dmesg | grep card
>> cardbus0: <CardBus bus> on cbb0
>> pccard0: <16-bit PCCard bus> on cbb0
>> ---------
>> rc.conf:
>> pccard_enable="YES"
>> ---------
>>
>> but when I insert the card: nothing.
>>
>> What can I do ?
>>
>> Thanks for help.
>>
>> Felix
>>
>
> Check, if you have if_ath.ko is loaded (kldstat -v | grep ath)
>
> Lars
>
Yauu: that was fast ! Thanks a lot for your response.
Yes if_ath loaded:
kldstat -v | grep ath
28 ath_hal
37 ath_rate
38 pci/if_ath
39 cardbus/if_ath
What else can i inverstigate ?
Felix
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"