Re: netgear wg511t pccard on Clevo m120_w
"felix.schalck" <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
Dana Ferguson wrote: > Opps forgot the list... > > Here is how my Atheros A/B/G card is set up in rc.conf. > > > # -- sysinstall generated deltas -- # Sun Sep 17 13:05:14 2006 > # Created: Sun Sep 17 13:05:14 2006 > # Enable network daemons for user convenience. > # Please make all changes to this file, not to /etc/defaults/rc.conf. > # This file now contains just the overrides from /etc/defaults/rc.conf. > inetd_enable=YES > nfs_client_enable=YES > sshd_enable=YES > nisdomainname="fergus" > nis_client_enable=YES > gdm_enable="YES" > usbd_enable=YES > hostname=FreeBSD. > ifconfig_ath0="dhcp ssid Ferguson_Ranch" > ntpd_enable=YES > sendmail_enable=YES > network_interfaces=ath0 > > Dana > > > On Sat, 2006-10-07 at 18:17 +0200, felix.schalck wrote: > > >> Lars Engels wrote: >> >>> On Sat, Oct 07, 2006 at 06:05:41PM +0200, felix.schalck wrote: >>> >>> >>>> Hi, >>>> >>>> I'm trying to get the Netgear wg511t working under 6.x. >>>> Card works well under linux. >>>> Dmesg shows: >>>> -------- >>>> #dmesg | grep card >>>> cardbus0: <CardBus bus> on cbb0 >>>> pccard0: <16-bit PCCard bus> on cbb0 >>>> --------- >>>> rc.conf: >>>> pccard_enable="YES" >>>> --------- >>>> >>>> but when I insert the card: nothing. >>>> >>>> What can I do ? >>>> >>>> Thanks for help. >>>> >>>> Felix >>>> >>>> >>> Check, if you have if_ath.ko is loaded (kldstat -v | grep ath) >>> >>> Lars >>> >>> >> Yauu: that was fast ! Thanks a lot for your response. >> Yes if_ath loaded: >> >> kldstat -v | grep ath >> 28 ath_hal >> 37 ath_rate >> 38 pci/if_ath >> 39 cardbus/if_ath >> >> What else can i inverstigate ? >> >> Felix >> Thanks for help, but i don't think my problem is a inet config prob. Trying to find a solution, I enabled cardbus debug. Here is what I get, when I insert the card: Status is 0x30000086 Status is 0x30000820 cbb0: card inserted: event=0x00000000, state=30000820 cbb0: cbb_power: 3V cbb0: cbb_power: 0V Any ideas from here ? Thanks a lot, Felix >> _______________________________________________ >> [email protected] mailing list >> http://lists.freebsd.org/mailman/listinfo/freebsd-mobile >> To unsubscribe, send any mail to "[email protected]" >> > _______________________________________________ > [email protected] mailing list > http://lists.freebsd.org/mailman/listinfo/freebsd-mobile > To unsubscribe, send any mail to "[email protected]" > > > _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"