Re: em0 t41

Norberto Meijome wrote:

>On Sun, 12 Nov 2006 11:55:14 -0500
>Understudy <[email protected]> wrote:
>
>  
>
>>The basic way to say this is that it shows up in the dmesg but it 
>>doesn't show a link light when I plug in the network patch cord. So I 
>>have been plugging in a pcmcia card and using the patch cord there.
>>    
>>
>
>what does 
>
>ifconfig em0
>
>show?
>
>once you've plugged the cable, did you do 
>
>ifconfig em0 up
>
>as root (or sudo from other user) ? 
>
>
>  
>

Per your request:
I have the patch cable plugged in no link light. I have a pcmcia card in 
so I can connect. The pcmcia card is ed1.
Gargoyle# ifconfig -a
em0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
        options=b<RXCSUM,TXCSUM,VLAN_MTU>
        ether 00:0d:60:fb:6b:27
        media: Ethernet autoselect
        status: no carrier
plip0: flags=108810<POINTOPOINT,SIMPLEX,MULTICAST,NEEDSGIANT> mtu 1500
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 16384
        inet6 ::1 prefixlen 128
        inet 127.0.0.1 netmask 0xff000000
ed1: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
        inet 10.0.0.148 netmask 0xffffff00 broadcast 10.0.0.255
        ether 00:50:ba:cb:54:f0
        media: Ethernet autoselect (100baseTX <full-duplex>)
        status: active

Gargoyle# ifconfig em0 up
Gargoyle# dhclient em0
em0: no link .............. giving up
Gargoyle#

And there is no link light. I have it enabled in the bios.

Sincerely,
Brendhan

_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"