Re: ral0 / cardbus problems on Lenovo T61
"Sander Vesik" <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
Unfortunately, yes, it also has it. While it only gives " cardbus0: Expecting link target, got 0x0", but the BBP read/write errors are still there. On 8/18/07, M. Warner Losh <[email protected]> wrote: > > In message: <[email protected]> > "Sander Vesik" <[email protected]> writes: > : Hi! > : > : I'm having trouble using a ral based card (MSI CB54G2) in a Lenovo T61. > Upon > : inserting the card (or the boot process for that matter), it prints: > : > : cardbus0: Expecting link target, got 0x0 > : cardbus0: Resource not specified in CIS: id=10, size 2000 > : ral0: <Ralink Technology RT2560> mem 0x88000000-0x88001fff irq 16 at > device > : 0.0 on cardbus0 > : ral0: MAC/BBP RT2560 (rev 0x00) RF RT2522 > : > : It then fails to read the MAC address from (gets a different wrong > answer > : every time) and upon trying to execute wpa_suplicant prints a lot of > "ral0: > : could not to write to BBP" and doesn't work. > : > : The same card works fine in a different (HP) laptop, so I'm assuming > thatteh > : card itself and ral driver are ok. Any pointers to getting this to work? > I > : need to return the HP laptop soonish and get the T61 to work ... > > Which rev of FreeBSD? And does the latest 7.0 snapshot have this > problem? > > Warner > _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"