Re: ACPI Attach (acpi_ibm) stops mouse from working
John Baldwin <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
On Monday 22 October 2007 12:04:52 pm Tom Judge wrote: > Hi, > > > I have recently setup an IBM/Lenovo T43 with RELENG_7 as of mid last > week, however I have a problem with the acpi_ibm module. > > If I add acpi_ibm_load="YES" to loader.conf I get the following message > during boot: > > psm0: unable to allocate IRQ > > This is followed by a message stating that the acpi_ibm module has > attached to IRQ 12. > > If I remove this module from loader.conf and boot the system the mouse > attaches and works as expected. If I then kldload acpi_ibm the module > attaches to acpi0. > > > Is there any way to make this work without loading the acpi module after > boot? Can you provide your acpidump as well as devinfo -rv output from both cases? (i.e. when it is loaded at boot and when it is kldloaded after boot) -- John Baldwin _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"