Re: (Retry) Bridging a wi-device with a LAN-adapter

In message: <[email protected]>
            Robert **UNKNOWN CHARSET** <[email protected]> writes:
: bridging does work, i have had it working with an sitecom wireless
: adaptor a Prism2 chipset card and a standard ethernet ne2000 ed0
: interface. I worked i could get dhcp responses and network traffic over
: the bridge. Just by following the man page of the wi driver.

Actually, bridging mostly works.

However, I've found that I can't attach Cisco and a few other cards
when bridging is enabled.  It apperas that somehow those packets don't
wind up in the right place, but instead go over the bridge (which
makes no sense to me having stared at the code, but I've had it happen
to me time and time again).  This is with BRIDGE, not ng_bridge.  I've
not investigated the latter.

Warner

To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message