Re: 7.0-RELEASE && panic after ~4 hours

Sepherosa Ziehau wrote:
> On Thu, Mar 27, 2008 at 1:53 PM, Sam Leffler <[email protected]> wrote:
>   
> I just did a rewrite of wi that takes a different tack that might also
>>  work for ipw.  I set the card in monitor mode and scan using net80211 to
>>     
>
> I tried that way, when I wrote the new driver for ipw2100.  It does
> not work on certain parts though: some parts can't hear packets or
> receive junked packets on channels above 11 when in monitor mode, but
> these parts work (e.g. scan) just fine in STA mode on channels above
> 11.
> Linux's intel driver uses different channel mask (different location
> in EEPROM) for IBSS and monitor mode, this channel mask contains less
> channels than the BSS channel mask.  Though IBSS mode just works fine
> on all BSS channels listed in BSS channel mask, monitor mode only work
> on channels listed in the other channel mask.
>
> BTW, do you also imply that you inject scan probe packets in monitor mode ;)?
>   

I can for wi; that's why I did the experiment.  I haven't tested a wide 
variety of cards (my Lucent cards are AWOL) but it works so far on 
various Intersil/Prism cards.  On older cards like the MA401 scanning is 
slower than using firmware as I sometimes don't see traffic on a channel 
for a scan but since these cards are 11b only it doesn't seem like a big 
deal (i.e. very few channels to visit).  The other thing I did was drop 
support for Symbol cards as the driver did numerous handstands to 
accomodate it.  The result is that wi is now one of the smallest drivers 
in lines of code.

    Sam
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"