Re: fprint (finger print sensor framework) port ready for testing

any luck on this.... ?

On Wed, Apr 16, 2008 at 2:43 AM, Simon Barner <[email protected]> wrote:

> Outback Dingo wrote:
> > pam_fprint works (see below) but when i try to run the fprint demo i get
> >
> > STATUS: No Devices Found
>
> Are you sure you have r/w access to the sensor's USB device?
> >
> > pam_fprint_enroll -f 7
> > This program will enroll your finger, unconditionally overwriting any
> selected
> > print that was enrolled previously. If you want to continue, press
> enter,
> > otherwise hit Ctrl+C
> >
> > Found device claimed by UPEK TouchStrip driver
> > Opened device. It's now time to enroll your finger.
> >
> > You will need to successfully scan your Right Index Finger 3 times to
> complete
> > the process.
> >
> > Scan your finger now.
> > upekts:error [read_msg] non-zero bytes in cmd response
> > upekts:error [read_msg28] expected response, got -1 seq=40
>
> Something seems to go wrong. I have never seenn this error message.
>
> Which sensor are you using? Can you send me the output of `usbdevs -vd'
> in a private mail please?
>
> --
> Best regards / Viele Grüße,                             [email protected]
>  Simon Barner                                                [email protected]
>
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"