Re: Wireless access points: consumer, commercial, or DIY?
John Nielsen <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
On Wednesday 23 July 2008, Henrik Brix Andersen wrote: > On Wed, Jul 23, 2008 at 01:58:42PM -0300, Nenhum_de_Nos wrote: > > if you could share those adjustable params of you, as I also have an AP > > based on atheros and FreeBSD 7-STABLE and when heavily used it dies. > > The client that makes this is another FreeBSD 7-STABLE, also atheros > > based (laptop from asus - F3T). > > I had to make adjustments to the hw.ath.hal.sw_brt and > hw.ath.hal.dma_brt sysctls to make the values better suited for the > PCI bus of the soekris. FWIW I'm happy with my FreeBSD- and Atheros-based access point and I didn't have to do anything special to get it working properly. I was already using the FreeBSD box as a NAT gateway though so YMMV. I've had good luck with some D-Link products but it depends on the (individual) device, and I agree with the OP's sentiments about "consumer" quality hardware. JN _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"