Re: Wireless access points: consumer, commercial, or DIY?

On Wed, 2008-07-23 at 17:50 -0500, Mark Bennett wrote:
> > I'm currently running X-Wrt which is the OpenWrt code base with a 
> > better web interface and bug fixes.
> 
> You might also look at dd-wrt here:
> 
> http://www.dd-wrt.com/wiki/index.php/Main_Page
> 
> I purchased and flashed a Linksys WRT54g Version 8 device, and used it
> at home for a few weeks with zero problems.  I'm planning to install it
> for a commercial client.  I became frustrated with the feature set on
> reasonably priced APs (try finding one that you can bridge to another AP
> securely, and good luck to you), as well as unreliable performance.
> Short of going to a Cisco or some other commercial level product, this
> seemed to be the best route.  dd-wrt has a very full feature set.
Are you really running full DD-WRT (as opposed to "micro") on v8 device,
or was statement about full feature set unrelated?

> 
> Some of the hardware mentioned on the dd-wrt site is commercial grade,
> look at Ubiquti among others.  Good luck,
> 
> Mark
> 
> 
> 
> 
> _______________________________________________
> [email protected] mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
> To unsubscribe, send any mail to "[email protected]"
-- 
Alexandre "Sunny" Kovalenko (Олександр Коваленко)

_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"