Re: Wpi keep disconnecting

David Booth <[email protected]>
Newsgroups gmane.os.freebsd.devel.mobile
Message-ID <[email protected]>
On Thursday 18 September 2008, you wrote:
> On Fri, Sep 19, 2008 at 3:57 AM, David Booth 
<[email protected]>wrote:
> > On Thursday 18 September 2008, Johann Hugo wrote:
> > > On Thursday 18 September 2008, Kevin Oberman wrote:
> > > > > From: David Booth <[email protected]>
> > > > > Date: Thu, 18 Sep 2008 07:13:42 -0500
> > > > > Sender: [email protected]
> > > > >
> > > > > On Thursday 18 September 2008, Mark Kirkwood wrote:
> > > > > > I would seriously doubt this is a router problem - I see
> > > > > > the same thing with an Asus laptop using wpi driver + WPA
> > > > > > encryption. In my case disabling the encryption was a
> > > > > > workaround (a very poor one I know). This appears to be a
> > > > > > Freebsd issue AFAIK, as for instance under Ubuntu I can
> > > > > > have WPA enabled with such disconnection occurring.
> > > > > >
> > > > > > regards
> > > > > >
> > > > > > Mark
> > > > >
> > > > > I have a similar experience with wpi in a dell laptop
> > > > > running 7 stable i386.  Without encryption, the connection
> > > > > will stay up without fail. If I enable WPA, it disconnects
> > > > > at seeming random intervals that are shortened by doing
> > > > > large file transfers. Sometimes it will go for a full day
> > > > > without disconnecting; however,  if I do a file ftp of a
> > > > > few hundred megs, it may disconnect after a just a few
> > > > > minutes.  I do not think that it is a hardware problem in
> > > > > either the card or the router as when I boot the laptop
> > > > > into windows and use the same router and same WPA settings,
> > > > > the connection remains rock solid even with successive
> > > > > large file transfers.
> > > >
> > > > This is a bit of a shot in the dark, but I happen to be on a
> > > > WPA connection today and I hit this one or something very
> > > > similar. Since I am on an Atheros, it may be different, but I
> > > > made the problem "go awa" with 'ifconfig ath0 -bgscan'.
> > > > bgscan should not interfere in any way with normal operation,
> > > > but I have seen issues from it for some time and al most
> > > > always turn off bgscan as the first attempt to "fix" mystery
> > > > disconnects.
> > >
> > > I've got a Dell 1720 with a wpi wireless adapter in it. It was
> > > also droping the connection very often, until I added -bgscan
> > > to my ifconfig line. Now it stays connected all the time.
> > > except if my AP reboots then it does not want to reconnect
> > > automatically.
> >
> > I gave it a try and that did not do the trick.  It died less than
> > two minutes into an ftp session with less than 300 MB
> > transferred. After restarting, it died in less than a minute.  
> > The only logged error messages for the interface are the usual
> > messages about Timeout resetting TX ring 3 or 4.
> >
> > > _______________________________________________
>
> have you tried updating to 7-stable?
>
> I have a dell laptop (inspiron 9400) with a wpi based adapter
> connected to a router (Linksys WRT54G f/w rev 7) over WPA. I
> normally have no problems with disconnections (w/ 7-stable, not
> 7.0-release), even with multiple long downloads using parallel
> connections (upto 10 per file). It works fine without any
> disconnections or problems until I run the Deluge bittorrent
> client. Once this start running, after a few minutes, all
> connections except Deluge stop (Deluge still runs fine). I cannot
> even ping the router. If I stop Deluge, other connections start
> working after a few minutes.
>
> Not sure if this is related, but I do have a problem when freebsd
> starts up. For some reason, the ip address and the route do not get
> setup when it boots up, although I can see the config scripts
> running. After I login, I neet to run /etc/netstart again before
> the ip address gets assigned. it gives a message 'invalid authmode'
> in both cases

I have the same hardware you do (inspiron 9400, intel 3945) running 
7-stable (really 7.1 pre-release at this point) .  I have no problem 
at startup connecting to a linksys wrv200 using wpa-psk using 
wpa_supplicant, but I get the seemingly random disconnects.  When I 
get the disconnect, ifconfig looks good except that the status shows 
not associated.  Executing /etc/rc.d/netif restart will usually get a 
reconnect on the first try.  It seems to be a wpa issue as using WEP 
on the same hardware results in a stable connection.

On another note, can you get your notebook to suspend (S3)?
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.