Re: RFC: PCI SD host controller driver & mmc/mmcsd modules improvements
Oleksandr Tymoshenko <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.arm,gmane.os.freebsd.current,gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
Alexander Motin wrote:
> Hi.
>
> Latest patches against 8-CURRENT (should also fit 7-STABLE) may be found
> at:
> http://people.freebsd.org/~mav/sdhci/
Thanks! That's just what I was looking for about three weeks ago :)
>
> I will be grateful for any feedbacks, comments and support.
7.1 requires s/kproc/kthread/ but otherwise works fine:
sdhci0: <RICOH R5C822 SD> mem 0xff9fb800-0xff9fb8ff irq 9 at device 1.2
on pci2
sdhci0: 1 slot(s) allocated
sdhci0: [ITHREAD]
mmc0: <MMC/SD bus> on sdhci0
mmc0: SD card: 507379712 bytes
mmcsd0: 483MB <MMC/SD Memory Card> (read-only) at mmc0
mmc0: setting transfer rate to 30.000MHz
mmc0: setting bus width to 4 bits
GEOM_LABEL: Label for provider mmcsd0s1 is msdosfs/SD.
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-arm
To unsubscribe, send any mail to "[email protected]"