Re: RFC: PCI SD host controller driver & mmc/mmcsd modules improvements
Alexander Motin <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
Henry Hu wrote: > I've tried your driver, and it worked fine at my laptop. > I have a Samsung R70, with built-in SD card reader(in fact, it can > read many cards, and there are 4 unknown devices related to it).The > transfer speed with dd bs=512 is almost 800KB/s, which I think is > fairly fast. bs=512 is a quite ineffective for any modern storage. With bigger bs you should get much bigger performance I think. > I'm testing it with a transcend 2G mini SD card, with SD-miniSD adapter. > I'm using 7-STABLE, so I changed kproc_create to kthread_create to > compile the mmcsd module. > There are errors, but the transfer completed normally. > sdhci0-slot0: Card inserted > mmc0: <MMC/SD bus> on sdhci0 > sdhci0-slot0: Command error 1 (opcode 8 arg 426 flags 101 dlen 0 dflags 0) > sdhci0-slot0: Command error 1 (opcode 8 arg 426 flags 101 dlen 0 dflags 0) This is not a problem. It means that your card does not support SDHC CMD8 command as it is not an SDHC actually. > mmcsd0: 1950MB <SD Memory Card> at mmc0 16MHz/4bit It means that top performance of this card on this controller is about 8MB/s. I expect that you may reach it on read operations if your card is not very old. -- Alexander Motin _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"