if_ath problem
dikshie <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
Hi, i have if_ath problem on an old IBM T41. FreeBSD totoro.sfc.wide.ad.jp 8.0-BETA2 FreeBSD 8.0-BETA2 #7: Sat Aug 15 19:34:06 JST 2009 [email protected]:/usr/obj/usr/src/sys/T41-8 i386 ath0: flags=8802<BROADCAST,SIMPLEX,MULTICAST> metric 0 mtu 2290 ether 00:05:4e:43:8d:ed media: IEEE 802.11 Wireless Ethernet autoselect (autoselect) status: no carrier ath0: <Atheros 5212> mem 0xc0210000-0xc021ffff irq 11 at device 2.0 on pci2 ath0: [ITHREAD] ath0: AR5212 mac 5.6 RF5111 phy 4.1 device wlan # 802.11 support options IEEE80211_DEBUG # enable debug msgs options IEEE80211_AMPDU_AGE # age frames in AMPDU reorder q's options IEEE80211_SUPPORT_MESH # enable 802.11s D3.0 support device wlan_wep # 802.11 WEP support device wlan_ccmp # 802.11 CCMP support device wlan_tkip # 802.11 TKIP support device wlan_amrr # AMRR transmit rate control algorithm device an # Aironet 4500/4800 802.11 wireless NICs. device ath # Atheros pci/cardbus NIC's device ath_hal # pci/cardbus chip support options AH_SUPPORT_AR5416 # enable AR5416 tx/rx descriptors device ath_rate_sample # SampleRate tx rate control for ath device wlan_xauth device wlan_acl totoro# ifconfig ath0 up scan ifconfig: unable to get scan results totoro# ifconfig ath0 ssid 000000HFC ifconfig: SSID: bad value totoro# any hints? thank you! -- -dikshie- _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"