Re: wi interface with Netgear 301/401 flakey

This is the most unstable I've seen FreeBSD in a long while, and
I've been using it for close on 7 years now.

I just had two crashes in qucik succession. The first crash was as
per my other E-mails... a ssh and IMAP connection were the only
things active.

When the crash happened rebooted and all seemed well for a couple of
minutes until I ended up with a console full of wi0 messages, and I
hadn't even used the wireless interface since the reboot!

Does anyone have any thoughts at all on a way to move forward?

Gavin

----- Original Message -----
From: "Gavin Cameron" <[email protected]>
To: "Matt Peterson" <[email protected]>
Cc: "Warren Block" <[email protected]>; "M. Warner Losh" <[email protected]>;
<[email protected]>
Sent: Thursday, August 08, 2002 3:02 PM
Subject: Re: wi interface with Netgear 301/401 flakey


> On Wed, Aug 07, 2002 at 09:53:57PM -0700, Matt Peterson wrote:
> > Next time post your dmesg output for wi0, I bet you're using old
> > firmware.
>
> I posted the firmware versions a couple of messages ago but here it is
> again.
>
> wi0: <Netgear MA301> port 0xe000-0xe03f,0xdc00-0xdc7f mem
0xee001000-0xee001fff ir
> q 5 at device 18.0 on pci0
> wi0: 802.11 address: 00:30:ab:1a:06:c6
> wi0: using RF:PRISM2.5 MAC:ISL3873
> wi0: Intersil Firmware: Primary 1.00.07, Station 1.03.06
>
> The card was working fine until last weekend when I cvsup'ed and
> updated my world.
>
> Gavin
>
> To Unsubscribe: send mail to [email protected]
> with "unsubscribe freebsd-mobile" in the body of the message
>


To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message